Add esphome config files

esphome/deurbel.yml

@@ -0,0 +1,32 @@
+esphome:
+  name: deurbel
+
+esp8266:
+  board: d1_mini
+
+# Enable logging
+logger:
+
+# Enable Home Assistant API
+api:
+  password: "ncc1701D"
+
+ota:
+  password: "ncc1701D"
+
+wifi:
+  ssid: "BARTANIET"
+  password: "ncc1701D"
+
+  # Enable fallback hotspot (captive portal) in case wifi connection fails
+  ap:
+    ssid: "Deurbel Fallback Hotspot"
+    password: "jeXv60iAylaV"
+
+captive_portal:
+
+binary_sensor:
+  - platform: gpio
+    pin: D3
+    name: "deurbelsignaal"
+    device_class: opening

esphome/nibemodbus.yaml

@@ -0,0 +1,88 @@
+esphome:
+  name: nibemodbus
+
+esp32:
+  board: esp32dev
+  framework:
+    type: arduino
+
+# Enable logging
+logger:
+
+# Enable Home Assistant API
+api:
+  password: ""
+
+ota:
+  password: ""
+
+wifi:
+  power_save_mode: none
+  ssid: "BARTANIET"
+  password: "ncc1701D"
+
+  # Enable fallback hotspot (captive portal) in case wifi connection fails
+  ap:
+    ssid: "Nibemodbus Fallback Hotspot"
+    password: "UgU5PVw37Yec"
+
+captive_portal:
+
+# Load nibe component
+external_components:
+  - source: github://elupus/esphome-nibe
+
+# Set pins required for LilyGo T-CAN485 board
+output:
+  - platform: gpio
+    id: ENABLE_PIN # Enable the chip
+    pin:
+      number: GPIO19
+      inverted: true
+  - platform: gpio
+    id: SE_PIN # Enable autodirection
+    pin:
+      number: GPIO17
+      inverted: true
+  - platform: gpio
+    id: ENABLE_5V_PIN # Enable 5V pin for RS485 chip
+    pin:
+      number: GPIO16
+      inverted: true
+
+# Configure uart that will be used
+uart:
+  rx_pin: GPIO21
+  tx_pin: GPIO22
+  baud_rate: 9600
+
+# Configure NibeGW
+nibegw:
+  udp:
+    # The target address(s) to send data to. May be a multicast address.
+    target:
+      - ip: 10.86.0.108
+        port: 10090
+
+    # List of source address to accept data from, may be empty for no filter
+    source:
+
+  acknowledge:
+    - MODBUS40
+
+  # Constant replies to certain requests cabe made
+  constants:
+    - address: MODBUS40
+      token: ACCESSORY
+      data: [
+            0x0A, # MODBUS version low
+            0x00, # MODBUS version high
+            0x01, # MODBUS address?
+      ]
+
+# Some helper functions to restart ESPHome from HA
+button:
+- platform: restart
+  name: Nibegw Restart
+- platform: safe_mode
+  name: Nibegw Safe Mode Boot